3COM WL-542 DRIVER

Your SNMP management agent needs to be configured with thisname so that it can communicate with your router. Check with your ISP as for what type ofconnection you should choose. No part of this documentation may be reproduced in any form or by any means or used to make any derivative work such as translation, Campus Drive, transformation, or adaptation without written permission from 3Com Corporation. WeightApproximately g 1. To restore the factory defaultsettings, click Reset. The Wireless Settings screen is displayed.

Uploader:	Gazahn
Date Added:	17 January 2008
File Size:	21.1 Mb
Operating Systems:	Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads:	1334
Price:	Free* [*Free Regsitration Required]

After you havefinished making changes to the table, click Apply.

For example, entering a keyword of xxx would block access to any URL that contains the string xxx. Or point us to the URL where the manual is located. Feedback About Your suggestions are very important to us. Air flow around the unit and 3coom the vents in the side of the caseis not restricted. To use the Setup Wizard: Introduction This chapter 3coom guide you through a basic installation of the Router, including: The system clockmay not update immediately.

Table of Contents Add to my manuals Add.

Time And Time Zone 5: DDNS is disabled by default. Marlborough, MA 3Com Corporation reserves the right to revise this documentation and to make changes in content from time USA to time without obligation on the part of 3Com.

CautionInformation that alerts you to potential loss of data orpotential damage to an application, system, or device. The usershould seek local advice on whether or not rf energy is permitted withinthe area of intended use.

If two devices allocatethemselves the same address, the conflict is detected and one of thedevices allocates itself a new address. The default URL is http: You must read the following safety information carefully before youinstall or remove the unit: ServerA computer in a network that is shared by multiple end stations.

3com OfficeConnect WL Manuals

The rates will switch automatically depending on range and environment. End User Software License Agreement Subject to the restrictions set forth herein, the Software is licensed to be used on any workstation or any network server owned by or leased to you, for your internal use, provided that the Software is used only in connection with this 3Com product.

Ensure that one of your computers has a copy of the new software imagefile 3coom on its hard disk or available on CD-ROM. Many ISPs do not require you to enter this information into the Router.

Page 35 8 Set the Wireless Channel you want to use from the Channel drop-down list.

3Com WL-542 Network Router User Manual

To restore the factory defaultsettings, click Reset. You can choose to either: Warnings contain directions that you must follow for your personal safety. Turning off the firewall protection will not leave your network completely vulnerable to hacker attacks, but 3Com recommends that you leave the firewall enabled whenever possible. To change the configuration of your computers to allow this, follow the instructions in this chapter.

Downloading to your computer - You can also download the user manual 3Com WL to your computer and keep it in your files. Firewall57Some ISPs require a host name. Conventions Feedback About Your suggestions are very important 3con us.

From the Start menu,choose Run and then enter winipcfg. The rates will switch automatically depending on range and environment. Water or moisture cannot enter the case of the unit.

You may need to restart your computerbefore you attempt this. This guide is intended for use by those responsible for installing andsetting up network equipment; consequently, it assumes a basic workingknowledge of LANs Local Area Networks and Internet Routers.

When inserting an ADSL RJ plug, be sure the tab on the plug clicks into position to ensure that it is properly seated.